Home › Guides › Real ear measurement
By Sandra Meyer, hearing care professional (Spanish qualification: audioprotesista), registration no. 2822, Professional College of Higher Health Technicians of the Valencian Community · Published 17 November 2026
When a hearing aid is fitted, the computer calculates how much it should amplify. But that calculation starts from an “average” ear, and yours isn’t average. Real ear measurement checks, inside your own ear, that the sound reaching it is what your hearing needs. Here we explain what it is and how it’s done.
1. What real ear measurement is
Real ear measurement (REM) is exactly what it sounds like: a measurement taken in your own ear. It’s a test that measures the sound that actually reaches your eardrum while you’re wearing the hearing aid.
To do it, a very thin silicone tube connected to a microphone is placed in your ear canal. The tube sits close to the eardrum, next to the hearing aid, and “hears” the same as your ear does.
2. Why the computer fitting alone isn’t enough
The manufacturer’s software calculates the amplification from your audiogram and an ear of average size and shape. But every ear is different: the canal may be shorter or longer, wider or narrower, and the receiver or earmould sits one way or another.
All of that changes the sound reaching the eardrum, especially the high frequencies, which are what make speech clear. So what the screen shows and what you actually hear may not match. Published studies have found this again and again: many hearing aids set up with the software alone fall well short of what the audiogram calls for at some frequencies.
That’s exactly what real ear measurement is for: to stop assuming and start measuring.
3. What the test involves, step by step
- We look into your ear with an otoscope, to check there’s no earwax in the way.
- We gently place the probe tube in your ear canal. It doesn’t hurt; at most you’ll feel a slight tickle.
- We put the hearing aid on over it, the way you normally wear it.
- We play recorded speech through a loudspeaker at different levels: soft, normal and loud.
- We compare on screen what reaches your eardrum with the target calculated for your audiogram.
- We adjust the hearing aid until the two curves are close together, and measure again.
All you have to do is sit back and relax. At the end we show you the screen and explain what it shows.

First, find out how you hear. Everything starts with a free hearing test: an hour to an hour and a half, with no obligation, and we explain the results at the end.
See the hearing test4. What you see on the screen
Two lines for each level. One is the target: how much sound your ear needs at each frequency, calculated from your audiogram using internationally recognised formulas. The other is what actually reaches your ear. When they’re close, the hearing aid is doing what your hearing needs.
5. What it means for you
Real ear measurement doesn’t make a hearing aid any better than it is. What it does is check that yours is set up for your ear rather than an average one. It’s a starting point that has been measured, not estimated.
After that, your opinion counts as much as the measurement: how you hear the television, voices at home, the street. The fine-tuning is based on both: the measurement and what you notice.
6. Does every centre do it?
In Spain it isn’t compulsory, and not every centre does it routinely. However, good-practice guidelines for fitting hearing aids, such as those of the American Academy of Audiology and the British Society of Audiology, recommend verifying the fitting with real ear measurements.
If you’re buying a hearing aid, anywhere, you can ask: “Will you be doing real ear measurements?” It’s a perfectly reasonable question.
7. How we do it
At Senti2 Moraira, Akustik Jávea and Akustik El Albir we use real ear measurement to check the settings: we make sure the hearing aid is giving your ear what your hearing needs, and adjust whatever needs adjusting.
We don’t do it for everyone: it depends on the case. If it makes sense for you, we’ll tell you and explain what we see.
If you already wear hearing aids and feel they never quite sound right, tell us. Sometimes the problem isn’t the device but the way it’s set up.
- American Academy of Audiology. Guidelines for the Audiologic Management of Adult Hearing Impairment, 2006.
- British Society of Audiology. Guidance on the verification of hearing devices using probe microphone measurements, 2018.
- Aazh H, Moore BCJ. The value of routine real ear measurement of the gain of digital hearing aids. Journal of the American Academy of Audiology, 2007.
Our team prepares these guides with the help of artificial intelligence tools; a registered hearing care professional reviews and approves them before publication.